>
Removal |
1. |
Remove the steering column upper and lower shrouds after loosening screws. |
2. |
Disconnect the multifunction switch connector (A). |
3. |
Remove the wiper & washer switch (A) by pushing the lock pin.
|
4. |
Remove the clock spring.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring") |
5. |
Loosen the screws (2EA) from the multifunction switch assembly (A). |
Installation |
1. |
Install the multifunction switch after connecting the connector. |
2. |
Install the clock spring.
|
3. |
Install the steering column upper and lower shrouds. |
4. |
Install the steering wheel.
|
Inspection |
1. |
Check IPM input/output specification of windshield
wiper/washer switch using the GDS. If the specification is abnormal,
replace the windshield wiper/washer switch module. |
2. |
Select option "Input/output monitoring". |
Starter Relay Repair procedures
Inspection
1.
Disconnect the battery negative terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay(A).
4.
Using an ohmmeter, check that there is continuity between each ...
Power Windows
The Engine Start/Stop Button must be in the ON position to be able to raise or
lower the windows.
Each door has a Power Window switch to control that door's window. The driver
has a Power Win ...
Intake Manifold Repair procedures
Removal and Installation
1.
Disconnect the negative terminal (A) from the battery.
Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
2.
Remove the engine room cover (A ...