>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Using a screwdriver or plastic panel remover, remove the cluster fascia upper panel (A). |
3. |
Using a screwdriver or plastic panel remover, remove the center fascia upper panel (A). |
4. |
Disconnect the heater control unit connector (A), clock and SSB connector (B). |
5. |
After loosening the screws, remove the heater control unit (A) from the center fascia upper panel. |
Installation |
1. |
Install the heater control unit to the center fascia upper panel. |
2. |
Install the center fascia upper panel. |
3. |
Install the cluster fascia upper panel. |
Inspection |
1. |
Check IPM input/output specification of windshield deicer
switch using the GDS. If the specification is abnormal, replace the
windshield deicer switch module. |
2. |
Select option "Input/output monitoring". |
3. |
To check the input value of windshield deicer switch in force mode, select option "Actuation test". |
Front Wheel Speed Sensor Repair procedures
Removal
1.
Remove the connector after removing the front wheel speed sensor clip.
2.
Remove the front wheel speed sensor.
(Refer to Driveshaft and Axle - "Front Axle Assembly")
3.
Install ...
Rear Door Window Glass Components and Components Location
Component Location
1. Rear door window glass
...
Front Pillar Trim Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protec ...