>
WARNING - Windshield heating
Do not use the or
position during cooling operation
in extremely humid weather. The difference between the temperature of the outside
air and that of the windshield could cause the outer surface of the windshield to
fog up, causing loss of visibility could cause an accident resulting in serious
injury or death. In this case, set the mode selection knob or button to the
position and fan speed control knob
or button to a lower speed.
✽ NOTICE
If the engine temperature is still cold after starting, then a brief engine warm up period may be required for the vented air flow to become warm or hot.
To defog inside windshield
1. Select desired fan speed.
2. Select desired temperature.
3. Press the defrost button ( ).
4. The outside (fresh) air position will be selected automatically.
If the outside (fresh) air position is not selected automatically, adjust the corresponding button manually.
If the position is selected, lower
fan speed is adjusted to a higher fan speed.
To defrost outside windshield
1. Set the fan speed to the highest (extreme right) position.
2. Set the temperature to the extreme hot (HI) position.
3. Press the defrost button ( ).
4. The outside (fresh) air position will be selected automatically.
If the position is selected, lower
fan speed is adjusted to a higher fan speed.
Components and Components Location
Components Location
1. Front strut assembly2. Front brake disc3. Tie rod end assembly4. Front sub frame5. Tension arm6. Lateral arm7. Front knuckle assembly
...
Repair procedures
Removal
1.
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
2.
Remove the bolts and disconnect the horn connectors, then remove the high pitch horn (A) and low pitch horn ...
Sunroof Guide Repair procedures
Replacement
1.
Remove the sunroof assembly.
(Refer to Sunroof - "Sunroof Assembly")
2.
Remove a drip link assembly (A) after lowering a guide thoroughly by pushing a slide to rear.
3.
Rem ...