Hyundai Equus: Waist Line Molding Repair procedures
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Body Side Molding / Waist Line Molding Repair procedures
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Body Side Molding / Waist Line Molding Repair procedures
| Replacement |
|
|
| 1. |
Using a screwdriver or remover, remove the front waist line molding (A). |
| 2. |
Using a screwdriver or remover, remove the rear waist line molding (B).
|
| 3. |
Install in the reverse order of removal.
|
Rear Wheel Guard Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...
Side Sill Molding Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...
See also:
Front Wheel Speed Sensor Repair procedures
Removal
1.
Remove the connector after removing the front wheel speed sensor clip.
2.
Remove the front wheel speed sensor.
(Refer to Driveshaft and Axle - "Front Axle Assembly")
3.
Install ...
Fuel Pressure Control Valve Troubleshooting
Signal Waveform
...
Body Control Module (BCM) Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel after loosening the mounting screws.
(Refer to Body - "Crash Pad Lower Panel")
3.
Disconnect t ...
Categories
Hyundai Equus Manuals
© 2011-2024 Copyright www.heqmanual.com