>
Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the E Module connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
Rear Pillar Trim Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...
Brake Pedal Repair procedures
Removal
1.
Remove the lower crash pad.
(Refer to Body - "Crash Pad")
2.
Disconnect the stop lamp switch connector (A).
3.
Remove the mounting bracket nut (B).
Tightening torque :
14. ...
Heater Control Unit Components and Components Location
Control Panel
Component
Connector Pin Function
Pin No.Connector AConnector B1GroundIgnition 22-FET (Gate)3Mode Control Actuator (Vent)FET (Drain Feedback)4Mode Control Actuator (Defrost)Sen ...