>
Removal |
1. |
Deflate tire & remove balance weights.
|
Handle the sensor with care. |
1. |
Remove the valve nut.
|
2. |
Discard the valve assembly. |
Installation |
|
1. |
Assemble valve to sensor and turn valve 3 times with the square part of the screw in the slot.
|
2. |
Mount assembly to wheel.
|
3. |
Tighten washer and nut by hand until the valve thread meets the nut built-in calibrated stop.
|
4. |
Using a torque wrench, tighten the nut to 8.0N,m (±1.0 N.m) |
1. |
Sensor mounting
|
Only use wheels designed to accommodate the TPMS sensor. |
1. |
Lubricate the tire bead not the rim. Excessive lubrication should not be applied. |
2. |
Start tire mounting approx. 5.9 in(15 cm) from valve. |
3. |
Move the mounting tool away from the valve.
|
4. |
Finish with mounting tool near to valve. |
5. |
Carry out inflation / pressure correction and then fit valve cap.
Sensor ID Writing (Wireless)
Sensor ID Writing |
Automatic-dimming function
Your mirror will automatically dim upon detecting glare from the vehicles traveling
behind you. The autodimming function can be controlled by the Dimming ON/OFF Button:
1. Pressing and hold the but ...
Solenoid Valve Components and Components Location
Components
1. Connected to air tube2. Bracket3. Connector
...
Repair procedures
Adjustment
TCM Learning
When shift shock is occurred or parts related with the transmission are replaced, TCM learning should be performed.
In the following case, TCM learning is required.
...