>
Removal and Installation |
1. |
Disconnect the negative terminal (A) from the battery.
|
2. |
Remove the air duct, air intak hose and the air cleaner assembly.
(Refer to Engine and transaxle assembly in this group) |
3. |
Loosen the drain plug (A) and drain the engine coolant. Remove the radiator cap (B) to speed draining.
|
4. |
Remove the throttle body. |
5. |
Remove the engine coolant temperature control assembly (A).
|
6. |
Remove the O-ring (A).
|
7. |
Installation is reverse order of removal. |
Crankshaft Position Sensor (CKPS) Repair procedures
Inspection
1.
Check signal waveform of CKPS and CMPS using a GDS.
Specification: Refer to “Waveform”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cab ...
Canister Close Valve (CCV) Schematic Diagrams
Circuit Diagram
...
Auto Light Sensor Repair procedures
Inspection
In the state of IGN1 ON, when the multi function switch
module detects auto light switch on, tail lamp relay output and head
lamp low relay output are controlled according to auto li ...