>

Hyundai Equus: Sub Fuel Sender Repair procedures - Fuel Delivery System - Engine Control/Fuel System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Sub Fuel Sender Repair procedures

Removal
1.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
2.
Folding the rear seat cushion.
3.
Remove the fuel pump service cover (A) after loosening the screws.

4.
Disconnect the sub fuel sender connector (A).
5.
Remove the sub fuel sender (B) from the fuel tank after removing mounting bolts.

Installation
1.
Install in the reverse order of removal.

Sub fuel sender installation bolt :
2.0 ~ 2.9 N.m (0.2 ~ 0.3 kgf.m, 1.4 ~ 2.2 lbf.ft)

   
When installing the sub fuel sender, be careful not to get the seal-ring entangled.
    Fuel Pump Repair procedures
    Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2. Folding the rear seat cushion. 3. Remove the fuel pump ...

    Fuel Filter Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System -"Release Residual Pressu ...

    See also:

    SRS Control Module (SRSCM) Description and Operation
    Description The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does ...

    Components and Components Location
    Component Location 1. Fuel filler door ...

    Water pump Troubleshooting
    Troubleshooting Water Pump SymptomsPossible CausesRemedyCoolant leakage • From the bleed hole of the water pump Visually check • Check leaks after about ten-minute warming up. • If ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com