>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad center panel.
(Refer to Body - "Crash Pad Center Panel") |
3. |
Remove the start/stop button connector (A) from the crash pad center panel. |
4. |
Remove the start/stop button (B) after loosening the screws. |
Installation |
1. |
Install the start/stop button after connecting the connector. |
2. |
Install the crash pad center panel. |
3. |
Connect the negative (-) battery terminal. |
Trunk Lid Key Holder Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...
Low tire pressure telltale
...
Rear Left Door Module (RLDM) Components and Components Location
Component
...