Hyundai Equus: SRS Control Module (SRSCM) Description and Operation
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Restraint / SRSCM / SRS Control Module (SRSCM) Description and Operation
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Restraint / SRSCM / SRS Control Module (SRSCM) Description and Operation
| Description |
The primary purpose of the SRSCM (Supplemental Restraints
System Control Module) is to discriminate between an event that warrants
restraint system deployment and an event that does not. The SRSCM must
decide whether to deploy the restraint system or not. After determining
that pretensioners and/or airbag deployment is required, the SRSCM must
supply sufficient power to the pretensioners and airbag igniters to
initiate deployment.
The SRSCM determines that an impact may require deployment of
the pretensioners and airbags from data obtained from impact sensors
and other components in conjunction with a safing function.
The SRSCM will not be ready to detect a crash or to activate
the restraint system devices until the signals in the SRSCM circuitry is
stabilized.
It is possible that the SRSCM could activate the safety
restraint devices in approximately 2 seconds but is guaranteed to fully
function after prove-out is completed.
The SRSCM must perform a diagnostic routine and light a
system readiness indicator when the ignition switch is in the ON
position. The system must perform a continuous diagnostic routine and
provide fault notice through a warning lamp indicator in the event of
fault detection. A serial diagnostic communication interface will be
used to facilitate servicing of the restraint control system.
SRSCM
...
See also:
Compass function
The Compass can be turned ON and OFF and will remember the last state when the
ignition is cycled. To turn the display feature ON/OFF:
1. Press and release the button
to turn the display feature ...
Rear Assist Arm Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to damage t ...
Front Strut Assembly Components and Components Location
Components
1. Insulator cap2. Insulator assembly3. Spring upper pad4. Dust cover 5. Bump stopper6. Coil spring7. Spring lower pad8. Shock absorber
...
Categories
Hyundai Equus Manuals
© 2011-2024 Copyright www.heqmanual.com