>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the floor console.
(Refer to Body - "Floor Console Assembly") |
3. |
Remove the spliter unit (A) after disconnecting the connectors and loosening the mounting bolts. |
Installation |
1. |
Install the spliter unit after connecting connector.
|
2. |
Install the floor console. |
3. |
Connect the negative (-) battery terminal and then check to operate the rear monitor. |
Headlight, position light, turn signal light, side marker light and front fog
light bulb replacement
(1) Position light
(2) Headlight (High)
(3) Headlight (Low)
(4) Front side marker light
(5) Front turn signal light
(6) Front fog light
1. Open the hood.
2. Disconnect the negative battery ...
Crash Pad Under Cover Repair procedures
Replacement
[LH]
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply ...
Specifications
Specifications
Purge Control Solenoid Valve (PCSV)
x Specification
ItemSpecificationCoil Resistance (x)14.0 ~ 18.0 [20°C(68°F)]
Fuel Tank Pressure Sensor (FTPS)
x Type: Piezo-Resistive Pr ...