>
Hyundai Equus Manuals

Hyundai Equus: Specifications - General Information - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Specifications

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / General Information / Specifications

Specification
Air Conditioner
Item
Specification
Compressor
Type
7VSX18
Oil type & Capacity
PAG 120± 10cc (4.1±0.3oz.)
Pulley type
Around rubber damper
Displacement
180cc/rev
Condenser
Heat rejection
18,500 kcal/h
Expansion valve
Type
Block type
Refrigerant
Type
HFC-134a (R-134a)
Capacity
700 ± 25g (24.7 ± 0.88oz.)

Blower Unit
Item
Specification
Fresh and recirculation
Operating method
Actuator
Blower
Type
Sirocco
Speed step
Auto + 8 speed
Speed control
Power mosfet
Air filter
Type
Particle filter

Heater and Evaporator Unit
Item
Specification
Heater
Type
Pin & Tube type
Heating capacity
4,850 ± 5% kcal/hr
Mode operating method
Actuator
Temperature operating method
Actuator
Evaporator
Cooling capacity
4,500 ± 5% kcal/hr
Temperature control type
Evaporator temperature sensor
A/C ON/OFF
ON: 2.1 ± 0.5°C, (35.8 ± 32.9 °F)
OFF: 0.6 ± 0.5°C, (33.1 ± 32.9 °F)

Tightening Torques
Items
N.m
kgf.m
lb-ft
Compressor
19.6 ~ 33.3
2.0 ~ 3.4
14.5 ~ 24.6
Condenser - Discharge hose
3.9 ~ 5.9
0.4 ~ 0.6
2.9 ~ 4.3
Condenser - Liquid tube
Compressor - Discharge hose
6.9 ~ 8.8
0.7 ~ 0.9
5.1 ~ 6.5
Compressor - Suction hose
Expansion valve - Evaporator
8.8 ~ 13.7
0.9 ~ 1.4
6.5 ~ 10.1

    General Information
    ...

    Special Service Tools
    Special Service Tools Tool (Number and name)IllustrationUse09977-3R000Disc & hub assembly bolt removerRemoval and installation of disc & hub assembly bolt ...

    See also:

    Sedan Side Body
    Side body A Front side member tooling hole (O8)Fender apron panel tooling hole (O7)Front door hinge upper mounting hole (O13)Front door hinge lower mounting hole (O13) Fender mounting hole (O6.6 ...

    Repair procedures
    Removal 1. Remove the steering column upper and lower shrouds after loosening screws. 2. Disconnect the multifunction switch connector (A). 3. Remove the wiper & washer switch (A) by p ...

    Front Wiper Motor Repair procedures
    Removal 1. Remove the windshield wiper arm (A) and blade after removing a nut. Tightening torque : 27 ~ 31 N.m (2.8 ~ 3.2 kgf.m, 20 ~ 23 lb-ft) 2. If necessary of removing the wiper blad ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com