Four air spring solenoid valves (‘-’ control) and one
ambient solenoid valve are embedded inside this solenoid valve block as
shown in the circuit diagram below. When connecting the air tube to the
solenoid valve block, carefully check the color dot which is marked on
the valve and tube so that all colors should be matched each other.
The pressure sensor is built in the solenoid valve block so
that it detects the internal pressure when lifting or lowering the
vehicle height. Also it senses the pressure of reservoir tank every 30
minutes when the vehicle is running.
Components
1. Connected to air tube2. Bracket3. Connector
...
Circuit diagram
1.
Solenoid valve connector terminal
2.
Solenoid valve terminal function
TerninalFunction1Air spring valve FL2Ambiance valve3Air spring valve RR4Air spring valve RL5Solenoid ...
See also:
Cup holder
WARNING - Hot liquids
Do not place uncovered cups of hot liquid in the cup holder while the
vehicle is in motion. If the hot liquid spills, you could be burned. Such a
burn to the driver cou ...
Automatic-dimming function
Your mirror will automatically dim upon detecting glare from the vehicles traveling
behind you. The autodimming function can be controlled by the Dimming ON/OFF Button:
1. Pressing and hold the but ...
Rear Center Seat Belt Retractor Repair procedures
Replacement
•
When installing the belt, make sure not to damage the retractor.
1.
Remove the rear package tray trim.
(Refer to Interior Trim - "Rear Package Tray T ...