>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel after loosening the mounting screws.
(Refer to Body - "Crash Pad Lower Panel") |
3. |
Disconnect the connector (A) from smart key unit, BCM and tilt & telescopic unit. |
4. |
Remove the smart key (A) and BCM unit (B) after loosening bolt and nuts. |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front left wheel guard. |
3. |
Remove the buzzer (A) after disconnecting the connector. |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the Trunk lid panel (A).
(Refer to Body - "Trunk lid panel") |
3. |
Remove the trunk lid switch from the license lamp and the trunk lid switch assembly (A) after loosening the bolts. |
4. |
Remove the trunk lid switch after disconnecting the connector (A). |
Inspection |
1. |
Check for continuity between the trunk open switch terminals. |
2. |
If continuity is not specified, inspect the switch |
Installation |
1. |
Install the smart key unit and BCM unit and then connect the connectors. |
2. |
Install the crash pad lower panel. |
3. |
Connect the negative (-) battery terminal. |
1. |
Install the buzzer. |
2. |
Install the front left wheel guard. |
3. |
Connect the negative (-) battery terminal. |
1. |
Install the license lamp and trunk lid switch assembly. |
2. |
Install the trunk lid back panel. |
3. |
Connect the negative (-) battery terminal. |
Multimedia system
✽ NOTICE
If you install an aftermarket HID head lamp, your vehicle’s audio and
electronic device may malfunction.
Prevent chemicals such as perfume, cosmetic oil, sun cream, hand clean ...
Mechanical Key
If the Smart Key does not operate normally, you can lock or unlock the door by
using the mechanical key.
Mechanical Key of Conventional Smart Key
Depress and hold the release button (1) and re ...
Rail Pressure Sensor (RPS) Schematic Diagrams
Circuit Diagram
...