>
Removal |
1. |
Disconnect the negatiev (-) battery terminal. |
2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing") |
3. |
Remove the RF receiver (B) after disconnecting the connector (A) and loosening the mounting bolt. |
Installation |
1. |
Install the RF receiver after connecting the connector. |
2. |
Install the glove box housning. |
3. |
Connect the negative (-) battery terminal. |
General Safety Information and Caution
Precautions
General Precautions
Please read the following precautions carefully before performing the airbag system service.
Observe the instructions described in this manual, or the airbags c ...
Side Sill Molding Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...
Injector Troubleshooting
Signal Waveform
...