>
Removal |
|
1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim") |
3. |
Disconnect the front side impact sensor connector (A), and
then remove the front side impact sensor mounting screws to remove the
sensor (B). |
1. |
Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
2. |
Remove the rear wheel house trim.
(Refer to Body - " Rear Wheel House Trim") |
3. |
Disconnect the rear side impact sensor connector (A), and
then loosen the rear side impact sensor mounting bolt to remove the rear
side impact sensor (B). |
Installation |
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
|
1. |
Install the new front side impact sensor with the screws, then connect the front side impact sensor connector.
|
2. |
Install the front door trim.
(Refer to Body - "Front Door Trim") |
3. |
Reconnect the battery negative cable. |
4. |
After installing the front side impact sensor, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
1. |
Install the new rear side impact sensor with a bolt and then connect the rear side impact sensor connector.
|
2. |
Install the rear wheel house trim.
(Refer to Body - "Rear Wheel House Trim") |
3. |
Reconnect the battery negative cable. |
4. |
After installing the rear side impact sensor, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Description and Operation
Description
Refer to the "Body Network System" for the abbreviation information.
The SMART KEY system is a system that allows the user to
access and operate a vehicle in ...
Starter Relay Repair procedures
Inspection
1.
Disconnect the battery negative terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay(A).
4.
Using an ohmmeter, check that there is continuity between each ...
Cluster Fascia Panel Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...