>
Removal |
1. |
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. |
2. |
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly") |
3. |
Remove the seat back cover.
(Refer to Body - "Front Seat Back Cover")
|
4. |
Loosen the SAB mounting nuts and remove the SAB module.
|
1. |
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. |
2. |
Remove the rear seat assembly.
(Refer to Body -"Rear Seat Assembly") |
3. |
Loosen the rear side seat back mounting bolt (2EA). |
4. |
Disconnect the rear side airbag assembly connector, and then remove the rear side seat back. |
5. |
Remove the rear side airbag assembly cover.
|
6. |
Loosen the rear side airbag module mounting nuts and remove the airbag module.
|
Installation |
Be sure to install the harness wires so they will not pinch or interfere with other parts. |
|
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the battery negative cable and wait for at least three minutes. |
3. |
Place a side airbag on the side airbag frame and tighten the side airbag mounting nuts (2EA).
|
4. |
Install a new seat back cover.
(Refer to Body - "Front Seat Back Cover") |
5. |
Install the front seat assembly, and then connect the side airbag harness connector. |
6. |
Recline and slide the front seat forward fully, make sure the harness wires are not pinched or interfered by other parts. |
7. |
Reconnect the battery negative cable. |
8. |
After installing the side airbag (SAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
9. |
Install a new front seat assembly.
(Refer to Body - "Front Seat Assembly") |
Be sure to install the harness wires so they will not pinch or interfere with other parts. |
|
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the battery negative cable and wait for at least three minutes. |
3. |
Place a side airbag on the side airbag frame and tighten the side airbag mounting nuts (2EA).
|
4. |
Install a new seat back cover.
(Refer to Body - "Rear Seat Back Cover") |
5. |
Connect the side airbag harness connector, and then install the rear side seat back.
|
6. |
Reconnect the battery negative cable. |
7. |
After installing the side airbag, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
8. |
Install a new rear seat assembly.
(Refer to Body - "Rear Seat Assembly") |
Battery saver function
The purpose of this feature is to prevent the battery from being discharged.
The system automatically turns off the parking lights when the driver turns
off the engine and opens the driver-si ...
Recommended lubricants and capacities
To help achieve proper engine and powertrain performance and durability, use
only lubricants of the proper quality.
The correct lubricants also help promote engine efficiency that results in improv ...
Keep paint and trim in good condition
Scratches or chips in the finish should be covered with "touch-up" paint as soon
as possible to reduce the possibility of corrosion. If bare metal is showing through,
the attention of a ...