>

Hyundai Equus: Shift Lever Repair procedures - Automatic Transmission Control System - Automatic Transmission System (SBC) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Shift Lever Repair procedures

Removal
1.
Remove the center console.
(Refer to Body - " Floor Consol")
2.
Disconnect the sports mode connector (A).

3.
Remove the shift cable assembly (A) from the shift lever assembly.

4.
Remove the shift lever assembly (A) by removing the bolts.

Tightening torque :
7.8 ~ 12.7 N.m (0.8 ~ 1.3 kgf.m, 5.8 ~ 9.4 lb-ft)

5.
Remove the clip (C ).
6.
Remove the shift cable (A) from the inhibitor by removing the nut (B).

Tightening torque :
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

7.
Remove the shift cable assembly (B) by removing the nuts (A).

Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

Installation
1.
Install in the reverse order of removal.
Adjustment
How To Adjust Shift Cable
1.
Insert the shift cable to the bracket and hold it with a new clip.
2.
Align the manual lever hole to the hole on the transmission case and hold the position with a bar.
3.
Eliminate shift cable free play of the shift cable.
4.
Firmly hold the special bolt with a spaner and tighten the nut (A) with the specified torque.

Tightening torque :
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

5.
Take off the bar holding the manual lever.
6.
Shifting the each position, check that the shift lever moves smoothly.
    Shift Lever Components and Components Location
    Components 1. Shift lever knob2. Shift lever boots3. Shift lever assembly4. Shift cable ...

    Driveshaft and axle
    ...

    See also:

    Buzzer Description and Operation
    Description Buzzer ouput the warning sound of PAS. PAS output the buzzer sound and warning sound. Cluster speaker makes buzzer sound, but externer AV AMP makes warning sound. ...

    Components and Components Location
    Component Location 1. Auto light sensor2. Head lamps3. Lighting switch (Auto)4. Tail lamps5. IPM (Instrument Panel Module) ...

    Recalling Position into Memory
    1. Check that the shift lever is in P (Park) and the Engine Start/Stop Button is in the ON position. 2. Press the desired memory button (1 or 2). The system will beep once, then the driver's ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com