>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the floor console upper cover.
(Refer to Body - "Floor Console Assembly") |
3. |
Remove the seat heater switch assembly (A) after disconnecting the connector and loosening the screws. |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the armrest from the second seat.
(Refer to Body - "Rear Seat Assembly") |
3. |
Using the remover, remove the armrest upper cover (A).
|
4. |
Remove the switch (A) from the armrest upper cover. |
Power Steering Hose Repair procedures
Replacement
-
Refer to the components illustration during removal or installation.
-
When installing, be sure to connect between hose to tube using a clamp as shown in the illustration.
- ...
Fuel Sender Assembly Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
"Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -""Release Residual Pres ...
Engine number
The engine number is stamped on the engine block as shown in the drawing. ...