>
Removal |
1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
2. |
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly") |
3. |
Remove the seat belt buckle switch.
(Refer to Body - "Front Seat Belt Buckle") |
Installation |
Be sure to install the harness wires so they will not pinch or interfere with other parts.
|
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
3. |
Install the seat belt buckle switch.
(Refer to Body - "Front Seat Belt Buckle") |
4. |
Install the front seat assembly.
(Refer to Body - "Front Seat Assembly") |
5. |
Reconnect the battery negative cable. |
6. |
After installing the seat belt buckle switch, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator should turn on for about six seconds and then go off. |
Seat Heater Switch Repair procedures
Removal
First Seat
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console upper cover.
(Refer to Body - "Floor Console Assembly")
3.
Remove the seat heater switch a ...
Fuel Tank Pressure Sensor (FTPS) Description and Operation
Description
Fuel Tank Pressure Sensor (FTPS) is a component of the
evaporative emission control system and is installed on the fuel tank,
the fuel pump, or the canister. It checks the purge con ...
For best battery service
The battery is in the trunk.
Keep the battery securely mounted.
Keep the battery top clean and dry.
Keep the terminals and connections clean, tight, and coated with petroleum
jelly or t ...