Hyundai Equus: Seat Belt Buckle Switch (BS) Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS) Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS) Description and Operation
| Description |
The SRSCM monitors the status of the driver and front
passenger seat belt buckle. The SRSCM provides one pin each for the
driver and front passenger seat belt buckle status input. The seat belt
buckle circuit operates from internal boost voltage supplied by the
SRSCM, and uses chassis ground for the signal return. The buckle status
modify the SRSCM deployment. If the buckle status is unbuckled, the
corresponding pretensioner will not be deactivated.
Side Impact Sensor (SIS) Repair procedures
Removal
•
Removal of the airbag must be performed according to the precautions/procedures described previously.
•
Before disconnecting the side impact sensor conn ...
See also:
Front Door Inside Handle Repair procedures
Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Disconnect the front door inside handle lamp connector (A).
3.
After loosening the mounting screws ...
Fluid Repair procedures
Service Adjustment Procedure
Oil level Check
A check of ATF level is not normally required during
scheduled services. If an oil leak is found, perform the oil level chec ...
6 Speed Clutch Control Solenoid Valve Schematic Diagrams
Circuit Diagram
...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com