>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Detach the lamp lens and reflector (A) from the room lamp with a flat-tip screwdriver. |
3. |
Remove the room lamp (A) after removing the screws. |
4. |
Replace the room lamp after removing the connectors (A). |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the lens (A) using a flat-tip screwdriver. |
3. |
Remove the vanity lamp (A) after loosening the mounting screws. |
4. |
Remove the vanity lamp assembly after disconnecting the connector (A). |
Installation |
1. |
Connect the connector and install the room lamp. |
2. |
Install the lamp reflector and lamp len. |
1. |
Install the vanity lamp. |
2. |
Install the lens. |
Inspection |
1. |
Check "IPM" input/output specification of room lamp using the GDS. |
2. |
Select option "Input/output monitoring". |
3. |
Select option "Actuation Test" to perform functional test. |
Programming HomeLink®
✽ NOTICE
When programming a garage door opener, it is advised to park the vehicle
outside of the garage. • It is recommended that a new battery be placed in the
hand-held transmitter ...
Rear Seat Frame Assembly Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply pro ...
Center Pillar Trim Repair procedures
Replacement
[Center Pillar Lower Trim]
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
prot ...