>
Replacement |
|
|
1. |
Remove the front seat.
(Refer to Front Seat - "Front Seat Assembly") |
2. |
Remove the rear seat.
(Refer to Rear Seat - "Rear Seat Assembly") |
3. |
Remove the front pillar trim.
(Refer to Interior Trim - "Front Pillar Trim") |
4. |
Remove the canter pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim") |
5. |
Remove the rear pillar trim.
(Refer to Interior Trim - "Rear Pillar Trim") |
6. |
Remove the sub sunvisor.
(Refer to Roof Trim - "Sunvisor") |
7. |
Remove the sunvisor and retainer.
(Refer to Roof Trim - "Sunvisor") |
8. |
Remove the assist handle.
(Refer to Roof Trim - "Assist Handle") |
9. |
Remove the overhead console lamp.
(Refer to Body Electrical System - "Overhead Console Lamp") |
10. |
Remove the room lamp.
(Refer to Body Electrical System - "Room Lamp") |
11. |
Remove the rear window glass.
(Refer to "Rear Window Glass") |
12. |
Remove the hands free mic.
(Refer to Body Electrical System - "Hands Free Mic") |
13. |
Using a screwdriver or remover, remove the inside rear view mirror cover (A). |
14. |
Disconnect the inside rear view mirror connector (A), auto
defog sensor connector (B), lane departure warning system (LDWS)
connector (C), rain sensor connector (D). |
15. |
Remove the handsfree mike (A) and lamp (B) by pushing down the hook using a screwdriver. |
16. |
Disconnect the roof trim main connectors (A) and the mounting clips in the front pillar.
[Driver's]
[Passenger's] |
17. |
Disconnect the connectors (A) and the mounting clips in the rear pillar.
[LH]
[RH] |
18. |
Using a clip remover, detach the roof trim assembly mounting clips. |
19. |
Pull back the roof trim assembly (A) through the place where the rear window glass was removed.
[Sadan]
[Limousine] |
20. |
Remove roof trim wiring harness (A) from the roof trim (B).
|
21. |
Install in the reverse order of removal.
|
Brake hoses and lines
Visually check for proper installation, chafing, cracks, deterioration and any
leakage. Replace any deteriorated or damaged parts immediately. ...
Change to "winter weight" oil if necessary
In some climates it is recommended that a lower viscosity "winter weight" oil
be used during cold weather. See section 8 for recommendations. If you aren't sure
what weight oil you s ...
Battery Specifications
Specifications
ItemSpecificationModel typeCMF100L-DINCapacity [20HR/5HR] (AH)100/80 Cold Cranking Amperage (A)780 (SAE) /624 (EN)Reserve Capacity (Min)190
...