>
Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the lower crash panel and then disconnect the rheostat connector. |
3. |
Check for intensity of new rheostat switch. If the light
intensity of the lamps changes smoothly without any flickering when the
rheostat is turned, it can be assumed that the rheostat is normal. |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the lower crash panel (A).
(Refer to Body - "Crash Pad Lower Pannel") |
3. |
Remove the crash pad switch assembly (A) after loosening the screws. |
4. |
Remove the rheeostat switch assembly (A) from lower crash panel. |
Installation |
1. |
Install the rheostat switch to the switch assembly. |
2. |
Install the switch assembly. |
3. |
Install the lower crash panel. |
Injector Schematic Diagrams
Circuit Diagram
...
Engine Coolant Temperature Sensor (ECTS) Description and Operation
Description
Engine Coolant Temperature Sensor (ECTS) is located in the
engine coolant passage of the cylinder head for detecting the engine
coolant temperature. The ECTS uses a thermistor that ...
6 Speed Clutch Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...