>
Adjustment |
|
1. |
Remove the front door trim.
(Refer to Front Door - "Front Door Trim") |
2. |
Carefully move the glass (A) until the glass mounting bolt are visible, then loosen them. |
3. |
Check that the glass moves smoothly. |
|
1. |
Loosen the screws (B) just enough for the striker to move.
|
2. |
Tap on the striker with a plastic hammer to adjust the striker. The striker will not move much, but will give some adjustment. |
3. |
Hold the outer handle out, and push the door against the body
to be sure the striker allows a flush fit. If the door latches
properly, tighten the screws and recheck. |
|
1. |
Check that the door and body edges are parallel. |
2. |
Place the vehicle on a firm, level surface when adjusting the doors. |
3. |
Adjust at the hinges (A) :
|
4. |
Grease the pivot portions of the hinges indicated. |
5. |
Check for water leaks. |
Fuel Pump Motor Components and Components Location
Components
Pin NO.ItemDescription1Upper body3-phase coil power supply, fuel delivery, and sealing2Stator assemblyCreates an N pole and S pole flux to induce the rotor to turn.3rotor assemblyTorqu ...
Repair procedures
Removal
Parking Brake Shoe
1.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear tire and wheel.
3.
Remove the brake caliper and Rear disc brake. (Refer to Bra ...
Heated Steering wheel Components and Components Location
Components Location
1. heated steering switch
...