When shift shock is occurred or parts related with the transmission are replaced, TCM learning should be performed.
In the following case, TCM learning is required.
• |
Transmission assembly replacement |
1. |
TCM learning condition
A. |
ATF temperature: 30 ~ 95°C (86 ~ 203°F) |
|
2. |
TCM learning procedure
- |
Repeat the below shift pattern four times or more with stepping on the brake. |
1. |
Drive the vehicle through all gears at D range. Drive from
stop to 1st to 2nd to 3rd to 4th to 5th to 6th to 7th to 8th with
keeping fixed throttle open. |
2. |
Down shift from 8th to 7th, 7th to 6th, 6th to 5th, 5th to 4th, 4th to 3rd, 3rd to 2nd, 2nd to 1st. |
3. |
Repeat the above driving pattern four times or more.
Up-shift throttle open : 15 ~ 30% |
|
Description
Automatic transmission system relies on various measurement
data to determine the current control status and extrapolate the
necessary compensation values. These values are used to ...
See also:
ETC (Electronic Throttle Control) System Schematic Diagrams
Circuit Diagram
...
Side impact air bag
Your vehicle is equipped with a side impact air bag in each front and outboard
rear seat. The purpose of the air bag is to provide the vehicle's driver and/or
the front and outboard rear pas ...
Seat belt restraint system
WARNING
For maximum restraint system protection, the seat belts must always be
used whenever the car is moving.
Seat belts are most effective when seatbacks are in the upright position.
Chi ...