>
Inspection |
1. |
After disconnecting the vapor hose from the PCV valve, remove the PCV valve. |
2. |
Reconnect the PCV valve to the vapor hose. |
3. |
Run the engine at idle, and put a finger on the open end of
the PCV valve and make sure that intake manifold vacuum can be felt.
|
4. |
If the vacuum is not felt, clean or replace the vapor hose. |
Smart Key Receiver Repair procedures
Removal
1.
Disconnect the negatiev (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Remove the RF receiver (B) after disconnecting the conne ...
Front Impact Sensor (FIS) Repair procedures
Removal
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connec ...
Components and Components Location
Component Location
1. Fender assembly
...