>
Removal |
1. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper") |
2. |
Remove the front blind camera (B) after removing the connector (A) and screws (4EA). |
1. |
Remove the screws, clip and trunk lid trim in the trunk.
(Refer to Body - "Trunk Lid") |
2. |
Remove the trunk lid panel. |
3. |
Remove the back view camera (B) after removing the connector (A) and screws (2EA). |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove glove box housing (A).
(Refer to Body - "Crash Pad") |
3. |
Disconnect the glove box housing connector (A). |
4. |
Remove the DIS head unit.
(Refer to Body - "DIS System") |
5. |
Remove the USB interface unit. |
6. |
Remove the front back view camera unit (A) after removing the nuts (2EA) and connector. |
Installation |
1. |
Install the front blind camera. |
2. |
Install the front bumper cover. |
1. |
Install the back view camera. |
2. |
Install the trunk lid panel and trim. |
1. |
Install the front back view camera unit. |
2. |
Install the USB interface unit |
3. |
Install the DIS head unit. |
4. |
Install the glove box and housing. |
Description and Operation
Description
Exhaust emissions (CO, HC, NOx) are controlled by a
combination of engine modifications and the addition of special control
components.
Modifications to the combustion chamber, int ...
Rear Disc Brake Components and Components Location
Components
1. Guide rod bolt2. Bleed screw3. Caliper body4. Caliper bracket5. Inner pad shim6. Brake pad7. Pad retainer
...
Rear Driveshaft (VL-VL TYPE) Components and Components Location
Component location
1. Rear driveshaft assembly(R)2. Rear driveshaft assembly(L)
...