>
Inspection |
1. |
Turn the ignition key to the "ON" position. |
2. |
Cover the front looking sensor to stop functioning. |
3. |
Head a light to the rearward looking sensor. |
4. |
The ECM should be darkened as soon as the rearward looking sensor detects the light.
|
5. |
When the reverse gear is engaged, the ECM should not be darkened.
When heading lights to both the front looking and rearward looking sensors, the ECM should not be darkened. |
Removal |
1. |
Remove the mirror wiring cover (A). |
2. |
Remove the connector (B). |
3. |
Push the inside rear view mirror base up to remove the inside rear view mirror assembly (A) after removing the screw.
|
Installation |
1. |
Install the mirror assembly. |
2. |
Install the mirror wiring cover and connector. |
Rear Shock Absorber Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to damage t ...
Warning type
The system will activate when:
1.The system is on
2.Vehicle speed is above 9.3 mph (15 km/h)
3.Other vehicles are detected in the rear side
If a vehicle is detected within the boundary of the ...
Tire chains
Tire chains, if necessary, should be installed on the drive wheels (rear wheels).
Be sure that the chains are installed in accordance with the manufacturer's instructions.
To minimize tire and c ...