>
Removal |
1. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover") |
2. |
Remove the bolts and disconnect the horn connectors, then remove the high pitch horn (A) and low pitch horn (B). |
Installation |
1. |
Install the horns after connecting the horn connectors. |
2. |
Install the front bumper cover. |
Inspection |
1. |
Remove the horn relay (A) from the engine room relay box. |
2. |
There should be continuity between the No.87and No.30
terminals when power and ground are connected to the No.85 and No.86
terminals. |
3. |
There should be no continuity between the No.87 and No.30 terminals when power is disconnected. |
Front
(1) Front map lamp
(2) Front room lamp
• : Press the button
to turn the map lamp on. This light produces a spot beam for convenient use
as a map lamp at night or as a personal lamp for th ...
Components and Components Location
Components Location
1. Front strut assembly2. Front brake disc3. Tie rod end assembly4. Front sub frame5. Tension arm6. Lateral arm7. Front knuckle assembly
...
Side Impact Sensor (SIS) Description and Operation
Description
The Side Impact Sensor (SIS) system consists of two kinds of
side impact sensor which are installed at each center of the front door
module (left and right) and two rear sensors whi ...