>
Removal |
1. |
Remove the steering column upper and lower shrouds after loosening screws. |
2. |
Disconnect the multifunction switch connector (A). |
3. |
Remove the wiper & washer switch (A) by pushing the lock pin.
|
4. |
Remove the clock spring.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring") |
5. |
Loosen the screws (2EA) from the multifunction switch assembly (A). |
Installation |
1. |
Install the multifunction switch after connecting the connector. |
2. |
Install the clock spring.
|
3. |
Install the steering column upper and lower shrouds. |
4. |
Install the steering wheel.
|
Inspection |
1. |
Check input/output specification of multifunction switch
using the GDS. If the specification is abnormal, replace the lamp or
wiper switch. |
2. |
If diagnosis is required on the multifunction switch, select model and "BCM". |
3. |
Select "Current data" and check the input/output condition of "Multifunction switch". |
Power steering pump, belt and hoses
Check the power steering pump and hoses for leakage and damage. Replace any damaged
or leaking parts immediately. Inspect the power steering belt (or drive belt) for
evidence of cuts, cracks, exce ...
Cup holder
WARNING - Hot liquids
Do not place uncovered cups of hot liquid in the cup holder while the
vehicle is in motion. If the hot liquid spills, you could be burned. Such a
burn to the driver cou ...
Fuel Pump Motor Components and Components Location
Components
Pin NO.ItemDescription1Upper body3-phase coil power supply, fuel delivery, and sealing2Stator assemblyCreates an N pole and S pole flux to induce the rotor to turn.3rotor assemblyTorqu ...