Inspect Sunroof Alignment
1. |
Adjust the difference between the height of the glass roof panel (A) and glass weatherstrip (B).
Standard value [mm(in.)] :
Front edge : - 0.2 (- 0.0079)
Rear edge : ±0.2 (±0.0079)
Side edge : ±0.4 (±0.0157)
|
|
2. |
Loosen the front screw and rear screw (A), adjust the height between the glass panel and roof panel.
Tightening torque :
2.0 ~ 3.9 N.m (0.2 ~ 0.4 kgf.m, 1.4 ~ 2.9 lb-ft)
|
|
Operating The Sunroof Emergency Handle
1. |
Use the sunroof emergency handle to close or open the sunroof
manually if the sunroof cannot be closed electronically due to motor or
controller electrical malfunction. |
2. |
Operating method.
B. |
Push the emergency handle up into the hexagonal drive (A) of
the sunroof motor. You must push hard enough to disengage the motor
clutch; otherwise the emergency handle will slip due to incomplete fit
in the motor. |
C. |
Carefully turn the emergency handle clockwise to close the sunroof. |
D. |
After closing the sunroof, wiggle the handle back and forth
as you remove the tool from the motor, to ensure the motor clutch
reengages. |
E. |
A 5mm hex socket may be used in place of the emergency handle, with a” Speeder” type handle. |
• |
Do not use power tools to operate the sunroof. |
• |
Damage to the components may occur. |
|
|
Components
1. Glass panel2. Decoration cover3. Drip link4. Guide assembly5. Drip rail6. Sunshade7. Defector8. Defector link 9. Seal tape10. Motor11. Frame12. Set plate
...
Component Location
1. Sunroof glass
...
See also:
Sliding the Sunroof
The Engine Start/Stop Button must be in the ON position before you can open or
close the sunroof.
Pressing the sunroof control lever backward or forward momentarily to the second
detent posit ...
Pre-safe seat belt (PSB) (if equipped)
The purpose of the pre-safe seat belt is to tighten the seat belt during emergency
braking, or when a loss of control is sensed.
CAUTION
The pre-safe seat belt activates only when the passenge ...
Smart Key Receiver Repair procedures
Removal
1.
Disconnect the negatiev (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Remove the RF receiver (B) after disconnecting the conne ...