>
Turn the tire hold-down wing bolt counterclockwise.
Store the tire in the reverse order of removal.
To prevent the spare tire and tools from “rattling” while the vehicle is in motion, store them properly.
If it is hard to loosen the tire holddown wing bolt by a hand, you can loosen it easily using the Jack handle.
1. Put the Jack handle (1) into the inside of tire hold-down wing bolt.
2. Turn the tire hold-down wing bolt counterclockwise by the Jack handle to utilize
the principles of the lever and fulcrum.
CAUTION
When you remove or store the spare tire, do not contact or bump the battery with the spare tire. Contacting or bumping the battery may cause failure of electrical circuits.
Rear Door Inside Handle Repair procedures
Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Disconnect the rear door inside handle lamp connector (A).
3.
After loosening the mounting screws, th ...
TPMS Receiver Repair procedures
Replacement
When the receiver first arrives for replacement:
1)
It will be in Virgin State.
2)
It will not have any sensor ID's memorized.
It ...
Description and Operation
Description
Emissions Control System consists of three major systems.
•
Crankcase Emission Control System prevents blow-by gas from
releasing into the atmosphere. This system recycles gas ba ...