>
Hyundai Equus Manuals

Hyundai Equus: Rear Wheel Speed Sensor Repair procedures - ESP(Electronic Stability Program) System - Brake System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Rear Wheel Speed Sensor Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Brake System / ESP(Electronic Stability Program) System / Rear Wheel Speed Sensor Repair procedures

Removal
1.
Remove the rear wheel speed sensor mounting bolt.
Tightening torque:
6.9 ~ 10.8 Nm (0.7 ~ 1.1 kgf.m, 5.1~ 8.0 lb-ft)

2.
Remove the rear wheel guard.
3.
Disconnect the rear wheel speed sensor connector (A), then remove the rear wheel speed sensor.

4.
Installation is the reverse of removal.
Inspection
1.
Measure the output voltage between the terminal of the wheel speed sensor and the body ground.
   
In order to protect the wheel speed sensor, when measuring output voltage, a 100 x resister must be used as shown.

2.
Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.

V_low : 0.59V ~ 0.84V
V_high : 1.18V ~ 1.68V
Frequency range : 1 ~ 2,000Hz
    Rear Wheel Speed Sensor Components and Components Location
    Components 1. Rear wheel speed sensor cable2. Rear wheel speed sensor ...

    Yaw-rate and Lateral G Sensor Description and Operation
    Description The ESP system is the shorten word of Electronic Stability Control system. This system recognizes a critical driving condition by Yaw-rate sensor, Lateral acceleration sensor and St ...

    See also:

    Rear Variable Damper Components and Components Location
    Components 1. Sub frame2. Rear shock absorber3. Air spring4. Rear upper arm5. Assist arm6. Trailing arm ...

    Steering Wheel Remote Controller (SWRC) Description and Operation
    Description The steering wheel remote controller (SWR) is composed of four switches and the right top switch is equipped with the Body CAN communication module. The left bottom remote control ...

    Cruise Control Switch Repair procedures
    Inspection [Measuring Resistance] 1. Disconnect the cruise control switch connector from the control switch. 2. Measure resistance between terminals on the control switch when each function ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com