>

Hyundai Equus: Rear Wheel Guard Repair procedures - Body Side Molding - Body (Interior and Exterior) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Rear Wheel Guard Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Remove the rear tire.
2.
After loosening the mounting clips and nut, then remove the rear wheel guard (A).

3.
Install in the reverse order of removal.
   
Replace any damaged clips.
    Front Wheel Guard Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply prote ...

    Waist Line Molding Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply prote ...

    See also:

    Rail Pressure Sensor (RPS) Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ConditionOutput Voltage (V)Idle Approx. 1.21, ...

    Compressor oil Repair procedures
    Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (P ...

    High beam operation
    To turn on the high beam headlights, push the lever away from you. Pull it back for low beams. The high beam indicator will light when the headlamp high beams are switched on. To prevent the ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com