>
Removal |
1. |
Remove the rear wheel and tire (A) from rear hub .
|
2. |
Support the lower portion of the rear axle with a jack securely. |
3. |
Disconnect the rear carrier with the rear shock absorber by loosening the bolts (A).
|
4. |
Unscrew the bracket retaining bolt (A) to disconnect the rear shock absorber (B) from the wheel housing panel.
|
5. |
Install in the reverse order of removal.
|
Inspection |
1. |
Repeatedly pump the piston rod (A) to check it for abnormal resistance or noises. |
2. |
If the piston rod does not move smoothly or creates abnormal noise when moving, replace the shock absorber assembly. |
3. |
To dispose of a shock absorber, fully extend the piston rod and drill a hole in the rear section (B) to release the gas.
|
Alternator Schematic Diagrams
Circuit Diagram
•
COM signal - When
controlling the voltage generated, the ECM sends the target voltage data
to the alternator via a PWM signal.(High voltage: 4V or hig ...
Master Cylinder Components and Components Location
Components
1. Reservoir cap2. Reservoir3. Grommet4. Cylinder pin5. Retainer6. Primary piston assembly7. Secondary piston assembly8. Master cylinder body
...
Overview
Description
The trip computer is a microcomputer- controlled driver information system that
displays information related to driving.
✽ NOTICE
Some driving information stored in the trip co ...