>

Hyundai Equus: Rear Seat Belt Retractor Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Replacement

•	When installing the belt, make sure not to damage the retractor.

1.	Remove the rear package tray trim. (Refer to Interior Trim - "Rear Package Tray Trim")

2.

After loosening the mounting bolt, then remove the rear seat belt retractor (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.

After loosening the retractor (A) mounting bolt, remove the rear seat belt (B).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.

Install in the reverse order of removal.

•	Make sure the connector is plugged in properly.

•	Replace any damaged clips.

Rear Seat Belt Retractor Components and Components Location

Component Location 1. Rear seat belt retractor ...

Rear Center Seat Belt Retractor Components and Components Location

Component Location 1. Rear center seat belt retractor ...

See also:

Severe driving conditions
A - Repeatedly driving short distance of less than 5 miles (8 km) in normal temperature or less than 10 miles (16 km) in freezing temperature B - Extensive engine idling or low speed driving for lo ...

Air Spring Repair procedures
Removal • Before replacing the relevant parts, use GDS equipment to fully discharge the air from the relevant parts. (Refer to Air Suspension System - "Repair procedures ( ...

Tire care
For proper maintenance, safety, and maximum fuel economy, you must always maintain recommended tire inflation pressures and stay within the load limits and weight distribution recommended for your ...

Categories

Hyundai Equus Manuals

© 2011-2024 Copyright www.heqmanual.com