>
Replacement |
[LH] |
|
|
1. |
Remove the rear seat back assembly [LH].
(Refer to Rear Seat - "Rear Seat Assembly") |
2. |
Push the lock pin (B), remove the rear seat headrest (A). |
3. |
Remove the rear seat back webbing guide cap (A). |
4. |
After loosening the mounting screws, then remove the rear seat back webbing guide (B). |
5. |
After loosening the mounting bolt, then remove the rear seat air inhalation duct (A). |
6. |
Pull out the rear seat headrest guides (A) while pinching both sides of the lower part of the guides, and remove them. |
7. |
Disconnect the connector (A). |
8. |
After loosening the mounting bolts and screws, then remove the air duct assembly (B). |
9. |
Remove the hog-ring clips (A) located in the rear part of the rear seat back. |
10. |
After removing the hog-ring clips on the rear of seat back and remove the rear seat back cover (A). |
11. |
Install in the reverse order of removal.
|
Fuel filter
A clogged filter can limit the speed at which the vehicle may be driven, damage
the emission system and cause multiple issues such as hard starting. If an excessive
amount of foreign matter accumu ...
Schematic Diagrams
Schematic Diagram
...
Rear Upper Arm Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to damage t ...