>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Using a screwdriver or plastic panel remover, remove the cluster fascia upper panel (A). |
3. |
Using a screwdriver or plastic panel remover, remove the center fascia upper panel (A). |
4. |
Disconnect the heater control unit connector (A), clock and SSB connector (B). |
5. |
After loosening the screws, remove the heater control unit (A) from the center fascia upper panel. |
Installation |
1. |
Install the heater control unit to the center fascia upper panel. |
2. |
Install the center fascia upper panel. |
3. |
Install the cluster fascia upper panel. |
Inspection |
1. |
The rear window defogger switch inputs can be checked using the GDS. |
2. |
To check the input value of rear window defogger switch, select option "IPM". |
3. |
Select option "Input/output monitoring". |
4. |
To check the input value of rear window defogger switch in force mode, select option "ACTUATION TEST". |
Components and Components Location
Component Location
1. Cluster assembly2. Battery sensor3. Washer fluid level sensor4. Fuel gauge sender
...
Loss of a Smart Key
A maximum of three Smart Keys including Card Type Smart Key can be registered
to a single vehicle. If you happen to lose your Smart Key, you should immediately
take the vehicle and remaining key t ...
Automatic Transmission Repair procedures
Removal
1.
Disconnect (-) terminal from the battery.
The battery is placed right side of the temporary tire in the trunk.
2.
Remove the under cover (A).
3.
Remove ...