>
Replacement |
1. |
Pull down rear door window glass by pressing the power window glass switch. |
2. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
3. |
After loosening the mounting screws, then remove the rear door belt outside weatherstrip. |
4. |
Remove the rear door belt inside weatherstrip. |
5. |
Remove the door frame inner cover. |
6. |
Remove the rear channel door frame garnish. |
7. |
Loosen the rear delta lower channel (C) mounting bolts. |
8. |
Remove the glass mounting plug hole (B). |
9. |
Carefully adjust the rear door window glass (A) until you can
see the bolt, then loosen them. Separate the glass from the glass run
and carefully pull the glass out through the window slot.
|
10. |
Install in the reverse order of removal.
|
Trunk Lid Weatherstrip Repair procedures
Replacement
1.
Remove the trunk lid weatherstrip (A).
•
Do not apply sealant to the body.
2.
Install in the reverse order of removal.
•
...
ECU Description and Operation
Description
Analyzes each variety sensor and communication data and executes air suspension control.
That part controls system and maintains function. ...
8LR Brake Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...