>
Replacement |
1. |
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass") |
2. |
Remove the rear door outside handle.
(Refer to Rear Door - "Rear Door Outside Handle") |
3. |
Loosen the rear door outside handle base mounting screw (A). |
4. |
Disconnect the rear door curtains motor connector (A). |
5. |
Using a screwdriver or remover, remove the extension cover (A). |
6. |
Loosen the mounting bolts, remove the rear door curtains (B).
|
7. |
Loosen the mounting bolts and nuts, remove the rear channel (A). |
8. |
Loosen the door latch (C) screws, remove the module assembly (B).
|
9. |
Disconnect the connectors (A) and rear door module wiring harness (B). |
10. |
Install in the reverse order of removal.
|
Floor mat anchor(s) (if equipped)
When using a floor mat on the front floor carpet, make sure it attaches to the
floor mat anchor(s) in your vehicle.
This keeps the floor mat from sliding forward.
WARNING
The following must be ...
Radiator Repair procedures
Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, then install it to pressure tester.
2.
Apply a pressure of 93 ~ 123kPa (0.95 ~ 1.25kgf/cmx, 14 ~ ...
Front Wheel Speed Sensor Components and Components Location
Components
1. Front wheel speed sensor cable2. Front wheel speed sensor
...