>
Hyundai Equus Manuals

Hyundai Equus: Rear Console Cover Repair procedures - Floor Console - Body (Interior and Exterior) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Rear Console Cover Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Floor Console / Rear Console Cover Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the floor console armrest.
(Refer to Floor Console - "Front Console Armrest")
2.
Loosen the mounting screws (A) located in the top of the rear console cover.

3.
Disconnect the connectors (A).

4.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
    Rear Console Cover Components and Components Location
    Component Location 1. Rear console cover ...

    Console Armrest Components and Components Location
    Component Location [Front Console Armrest] 1. Front console armrest [Rear Console Armrest] 1. Rear console armrest ...

    See also:

    Fuel Pump Control Module (FPCM) Schematic Diagrams
    Circuit Diagram ...

    Brake Booster Repair procedures
    Brake Booster Operating Test For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depress ...

    Intake Actuator Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com