>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Loose the nuts holding the rear combination lamp (outside) then disconnect the connector (A). |
3. |
Remove the rear combination lamp assembly (A). |
4. |
Replace the rear combination lamp assembly if the LED get out of order. |
Components and Components Location
Components
1. Rear bumper cover2. Rear bumper side bracket [LH]
...
27 Brake Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Troubleshooting
Troubleshooting
Diagnosis And Testing - Power Trunk Lid System
The power trunk lid system is a complex system containing
many components. In order to perform conclusive testing, or receive
out ...