>

Hyundai Equus: Rear Bumper Beam Assembly Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Beam Assembly Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the rear bumper cover. (Refer to Rear Bumper - "Rear Bumper Cover")

2.	Disconnect the bumper antenna connector (A).

3.	Disconnect the rear bumper joint connector mounting clip (A).

4.	Remove the mounting clips (B), then remove the rear bumper beam assembly (A) and then loosen the clips.

5.

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damage clips.

Rear Bumper Beam Assembly Components and Components Location

Component Location 1. Rear bumper beam assembly ...

Front Seat

...

See also:

Auto Door Lock/Unlock Features
You can modify some of the auto door lock/unlock features from the User Setting Mode. Refer to the User Setting Mode in section 4. ...

Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for the first 600 miles (1,000 km) you may add to the performance, economy and life of your vehicle. Do not race the ...

5 seater
Refer to your vehicle’s tire and loading information label for specific information about your vehicle's capacity weight and seating positions. The combined weight of the driver, p ...

Categories

Hyundai Equus Manuals

© 2011-2024 Copyright www.heqmanual.com