>
Hyundai Equus Manuals

Hyundai Equus: Rain Sensor Repair procedures - Windshield Wiper/Washer - Body Electrical System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Rain Sensor Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body Electrical System / Windshield Wiper/Washer / Rain Sensor Repair procedures

Removal
   
The dust or foreign substance on the rain sensor have a bad effect upon the rain sensor capability,so protect the sensor surface with protection cover until installing the rain sensor to bracket for accurate funtion.
The coupling pad on the rain sensor surface has adherive strength, so the coupling pad could stick to the windshield by environment condition during the using time.
If separate it by force, it could be damaged. So make sure to separate the rain sensor from the windshield carefully.
1.
Remove the rain sensor and LDWS unit cover (A) first.

2.
Remove the wiring harness connector from sensor.

3.
Be careful not to damage the cover latch by applying excessive force. To remove the rainsensor, pull aside the latch bracket hele with a small flat - blade screwdriver (A).
4.
Rain sensor module is attached to the front windshield by glue replacing the front windshield, remove the rain sensor module from the existing front windshield and install on the new front windshield.
Installation
   
•
In case of the windshield with reflection layer which reflects the infrared rays in sensing field, should install the rain sensor into the field removed the reflection layer.
•
Install the rain sensor after some time and be care not to be settled the dust after installation.
1.
Install the rainsensor bracket to the windshield glass using the tape.

   
It is very important that the coupling pad pushes the windshield completely to stick to each other without bubbles.
2.
Connect the rainsensor connector, and then install the sensor cover.
    Rain Sensor Description and Operation
    Description Integrated Rain Sensor Integrated rain sensor (A) controls three systems: front wiper, auto-light, and central air conditioner. 1. Wiper Control System When "AUTO" switch signal i ...

    Rear Curtain System
    ...

    See also:

    Buzzer Description and Operation
    Description Buzzer ouput the warning sound of PAS. PAS output the buzzer sound and warning sound. Cluster speaker makes buzzer sound, but externer AV AMP makes warning sound. ...

    Solenoid Valve Description and Operation
    Description Four air spring solenoid valves (‘-’ control) and one ambient solenoid valve are embedded inside this solenoid valve block as shown in the circuit diagram below. When connecting the ...

    Fuel Pressure Control Valve Description and Operation
    Description Fuel Pressure Control Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on vario ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com