>

Hyundai Equus: Rail Pressure Sensor (RPS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Rail Pressure Sensor (RPS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
Condition
Output Voltage (V)
Idle
 Approx. 1.2
1,500 rpm
2.2 ~ 2.5
6,300 rpm
 Approx. 3.0

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group).
   
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).
4.
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.

Installation
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.

Rail Pressure Sensor Installation:
29.4 ~ 34.3 N.m (3.0 ~ 3.5 kgf.m, 21.7 ~ 25.3 lb-ft)

    Rail Pressure Sensor (RPS) Schematic Diagrams
    Circuit Diagram ...

    Fuel Tank Pressure Sensor (FTPS) Description and Operation
    Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge con ...

    See also:

    Components and Components Location
    Components [Sunroof Type] 1. Roof trim2. Sunvisor [RH]3. Sunvisor [LH]4. Assist handle bracket [Limousine Type] 1. Roof trim2. Sunvisor [RH]3. Sunvisor [LH]4. Assist handle bracket ...

    Components and Components Location
    Component Location 1. Head lamp (High) 2. Head lamp (Low)3. Front fog lamp4. Front turn signal lamp5. Door mirror lamp6. High mounting stop lamp7. Tail/stop lamp8. Rear turn signal lamp9. Back up ...

    Rear Driveshaft (VL-VL TYPE) Repair procedures
    Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub.     Be carefu ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com