>
Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the PCSV connector. |
3. |
Measure resistance between the PCSV terminals 1 and 2. |
4. |
Check that the resistance is within the specification.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Disconnect the purge control solenoid valve connector (A). |
3. |
Disconnect the vapor hose (B) from the purge control solenoid valve. |
4. |
Remove the valve after removing the bolt (C). |
Installation |
|
|
1. |
Install in the reverse order of removal.
|
Schematic Diagrams
Circuit Diagram
...
Input Speed Sensor Schematic Diagrams
Circuit Diagram
...
Waist Line Molding Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...