>
Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the E Module connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification.
|
Removal |
1. |
Draining ATF totally.
(Refer to Hydraulic system - "Fluid") |
2. |
Disconnector the E-Module connector (A).
|
3. |
Remove the oil pan (A).
|
4. |
Remove the valve body assembly (A). |
5. |
Disconnect the pressure switch connector (A). |
6. |
Remove the pressure switch (A).
|
Installation |
1. |
Install in the reverse order of removal.
|
Upper Arm Repair procedures
Removal
[Front Upper arm]
1.
Removal the front wheel & tire.
Tightening torque :
90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft)
2.
Removal the air strut assembly.
(Refer ...
MTS Antenna Repair procedures
Removal
1.
Remove the roof antenna.
(Refer to Audio - "Antenna")
(Refer to AVN System - "Roof Antenna")
Installation
1.
Install the roof antenna.
(Refer to Audio - "Antenna")
(Refer to AV ...
ECU Components and Components Location
Components Location
1. ECU2. ECU bracket3. ECU support
...