>
Removal |
|
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the left trunk trim in the trunk. (Refer to the Body group - "Trunk") |
3. |
Remove the power trunk connecting rod (B) after removing the push rod pin (A).
|
4. |
Remove the power trunk module & drive unit (A) after removing the bolts, nut and connector. |
Installation |
1. |
Install the power trunk module & drive unit.
|
2. |
Install the push rod to the ball joint. |
3. |
Connect the connector (18P). |
4. |
Install the left trunk trim. |
5. |
Connect the negative (-) battery terminal and check the power trunk module correctly.
|
8LR Brake Control Solenoid Valve Specifications
Specifications
Direct control VFS[8LR/B]
x Control Type : Normal low type
Control Pressure kpa (kgf/cmx, psi)0 ~ 2108.42(0 ~ 21.5, 0 ~ 305.80)Current value(mA)0~1100 Internal r ...
CVVT Oil Control Valve (OCV) Specifications
Specification
ItemSpecificationCoil Resistance (x)6.9 ~ 7.9 [20°C(68°F)]
...
Fuel Pump Control Module (FPCM) Description and Operation
Description
The fuel pump control module (FPCM) is installed on the right
side of the trunk compartment. It controls the BLDC (Brushless DC)
motor mounted inside the variable low pressure fuel ...