>
Inspection |
1. |
Check the power trunk module input/output value by using the
GDS. If the operation of power trunk module is abnormal, replace power
trunk drive unit. |
2. |
To check the DTC of the power trunk module, select "PTM" |
3. |
Select "Input/output monitoring". |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the trunk trim in the trunk.
(Refer to Body - "Trunk") |
3. |
Disconnect the power striker connector (A). |
4. |
Remove the power striker (A) after removing the screws. |
Installation |
1. |
Install the power striker and connector. |
2. |
Install the trunk trim. |
3. |
Connect the negative (-) battery terminal and check the power trunk module correctly. |
Cowl Side Trim Components and Components Location
Component Location
1. Cowl side trim
...
Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Specification: Refer to "Specification"
Removal
1.
Tur ...
Front Air Strut Assembly Components and Components Location
Components
1. Air spring2. CDC damper3. Connector4. Air tube connector
1. Insulator cap2. Insulator assembly3. Spring upper pad4. Dust cover5. Bump stopper6. Coil spring7. Shock absorber
...